Super-micro-computer SUPERO X8SIA-F Manual de usuario descargar pdf (Pagina 36)

2-10

X8SIA/X8SIA-F User's Manual

2-3 System Memory

CAUTION

Exercise extreme care when installing or removing

DIMM modules to prevent any possible damage.

Platform DIMM Type Intel® Xeon® Series Processors

X8SIA/X8SIA-F Non-ECC UDIMM Only Not Supported

ECC UDIMM Only Supported (see Table 1)

RDIMM Only (with ECC) Supported (see Table 2)

Mixed ECC with non-ECC Not Supported

Mixed UDIMM/RDIMM Not Supported

Table 1 - DDR3 ECC/Unbuffered (UDIMM) Memory Support

ECC UDIMM 1Gb (x8 DRAM) 2Gb (x8 DRAM)

Single Rank Up to 4GB

(4 x 1GB DIMM Modules)*

Up to 8GB

(4 x 2GB DIMM Modules)*

Dual Rank Up to 8GB

(4 x 2GB DIMM Modules)*

Up to 16GB

(4 x 4GB DIMM Modules)*

Quad Rank Not Supported Not Supported

*Note: For ECC UDIMMs, only Slot 1 and Slot 2 may be populated per channel.

How to Install DIMMs

1. Insert the desired number of DIMMs into the memory slots, starting with

DIMM1A (Slot 1, Channel A - see Figure A on the following page). Insert each

DIMM module vertically into its slot. Pay attention to the notch along the bot-

tom of the module to prevent incorrect DIMM module installation.

2. Gently press down on the DIMM module until it snaps into place in the slot.

Repeat step 1 to install DIMM1B if needed. See Page 2-13 for details.

Memory Support

The X8SIA/X8SIA-F supports up to 16GB of DDR3 ECC UDIMM or up to 32GB

of ECC DDR3 RDIMM (1333/1066/800 MHz in 6 DIMM slots.) Populating these

DIMM modules with a pair of memory modules of the same type and same size

will result in interleaved memory, which will improve memory performance. Please

refer to the table below:

Note: Check the Supermicro website for a list of memory modules that

have been validated with the X8SIA/X8SIA-F motherboard.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 108 109

Sin comentarios

Super-micro-computer SUPERO X8SIA-F Manual de usuario Pagina 36