SUPER MICRO Computer SUPERSERVER 6015B-T Manual de usuario Pagina 24
- Pagina / 144
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
2-8
S
UPERSERVER 6015B-3/6015B-T User's Manual
2-5 Checking the Serverboard Setup
After you install the 6015B-3/6015B-T in the rack, you will need to open the top
cover to make sure the serverboard is properly installed and all the connections
have been made.
1. Accessing the inside of the System (see Figure 2-5)
First, grasp the two handles on either side and pull the system straight out until it
locks (you will hear a "click"). Next, depress the two buttons on the top of the chas-
sis to release the top cover (1). Push the cover away from you (toward the rear of
the chassis) until it stops (2). You can then lift the top cover from the chassis to
gain full access to the inside of the server.
To remove the system from the rack completely, depress the locking tabs in the
chassis rails (push the right-side tab down and the left-side tab up) to continue to
pull the system out past the locked position.
2. Check the CPUs (processors)
You may have one or two processors already installed in the serverboard. Each
processor needs its own heatsink. See Chapter 5 for instructions on processor and
heatsink installation.
3. Check the system memory
Your server system may have come with system memory already installed. Make
sure all DIMMs are fully seated in their slots. For details on adding system memory,
refer to Chapter 5.
4. Installing add-on cards
If desired, you can install add-on cards to the system. See Chapter 5 for details
on installing PCI add-on cards.
5. Check all cable connections and airfl ow
Make sure all power and data cables are properly connected and not blocking the
chassis airfl ow. See Chapter 5 for details on cable connections.
- SUPER 1
- Manual Revision 1.0b 2
- Release Date: July 11, 2007 2
- About This Manual 3
- Manual Organization 3
- Table of Contents 6
- Chapter 4: System Safety 7
- Chapter 7: BIOS 9
- Appendices: 9
- Chapter 1 11
- Introduction 11
- 1-2 Serverboard Features 12
- 1-3 Server Chassis Features 13
- FBD DIMM 15
- 1-4 Contacting Super Micro 16
- Chapter 2 17
- Warnings and Precautions! 18
- Rack Mounting Considerations 19
- Installing the Inner Rails 20
- Installing the Outer Rails 21
- Chapter 3 27
- 27
- System Interface 27
- 3-3 Control Panel LEDs 28
- 3-4 Drive Carrier LEDs 29
- Chapter 4 31
- System Safety 31
- 4-3 ESD Precautions 33
- LITHIUM BATTERY 34
- BATTERY HOLDER BATTERY HOLDER 34
- Chapter 5 35
- Advanced Serverboard Setup 35
- Installing the Processor 36
- Installing the Heatsink 38
- Removing the Heatsink 38
- 5-3 Connecting Cables 39
- Connecting the Control Panel 40
- 5-4 I/O Ports 41
- 5-5 Installing Memory 41
- Note: Notch 42
- 5-6 Adding PCI Cards 43
- 5-7 Serverboard Details 44
- Connector Description 45
- 5-8 Connector Defi nitions 46
- Overheat/Fan Fail LED (OH) 47
- NIC1 LED 47
- NIC2 LED 47
- Chassis Intrusion 49
- Fan Headers 49
- Serial Ports 49
- Power Supply Fail Header 49
- Wake-On-LAN 51
- Wake-On-Ring 51
- SMBUS_PS 51
- 5-9 Jumper Settings 53
- 5-10 Onboard Indicators 55
- Floppy Connector 56
- IDE Connectors 57
- SATA Ports 57
- SAS Ports (X7DBR-3 58
- Chapter 6 59
- Advanced Chassis Setup 59
- 6-2 Control Panel 60
- 6-3 System Fans 61
- Removing the Front Bezel 62
- Accessing the Drive Bays 63
- SAS/SATA Drive Installation 64
- 6-5 Power Supply 67
- Screws on inside edge 68
- Chapter 7 69
- BIOS 69
- 7-2 Running Setup 70
- 7-3 Main BIOS Setup 70
- Main BIOS Setup Menu 71
- Main Setup Features 71
- 7-4 Advanced Setup 75
- Hardware Monitor Logic 86
- Realtime Sensor Data 91
- 7-5 Security 92
- 7-6 Boot 93
- 7-7 Exit 94
- Appendix A 95
- BIOS POST Messages 95
- Appendix B 101
- BIOS POST Codes 101
- Appendix B: BIOS POST Codes 103
- Appendix C 107
- Creating a RAID 0 Volume 110
- Creating a RAID 1 Volume 111
- Deleting RAID Volume 114
- with RAID Functions 116
- Appendix D 117
- Adaptec HostRAID Setup 117
- Confi guring SATA RAID 118
- Managing Arrays 120
- Confi guring Disk Drives 121
- Creating Arrays 124
- Rebuilding Arrays 130
- Using the Disk Utilities 132
- Appendix E 137
- Appendix F 141
- System Specifi cations 141
- Regulatory Compliance 143
Relacionado con productos y manuales para Barebones Servidor SUPER MICRO Computer SUPERSERVER 6015B-T
(124 paginas)Panasonic NN-GT 337 WZTE manuels
Manuels d'utilisation et guides de l'utilisateur pour Micro-ondes Panasonic NN-GT 337 WZTE.
Nous fournissons des manuels en pdf 1 Panasonic NN-GT 337 WZTE à télécharger gratuitement par type de document : Manuel de l'utilisateur
Comentarios a estos manuales