SUPER MICRO Computer SUPERSERVER 6012P-6 Manual de usuario descargar pdf (Pagina 44)

5-8

SUPERSERVER 6012P-6 User’s Manual

Figure 5-5b. Top View of DIMM Slot

Figure 5-5a. Side View of DIMM Installation into Slot

To Install: Insert module vertically and press down until it snaps into

place. Pay attention to the bottom notch.

To Remove: Use your thumbs to gently push each release tab outward

to free the DIMM from the slot.

4. When installing modules into the two Bank 2 slots, you will need to

remove the power supply due to space constraints. Memory slots are

positioned at a 25 degree angle to fit full-sized memory modules into a

1U chassis.

Memory Support

The P4DPR-6GM+ only supports ECC registered DDR-200 (PC1600) SDRAM

memory. DDR-266 (PC2100) SDRAM is supported but only at 200 MHz (DDR-

200 speed). PC100/133 SDRAM is not supported. You should not mix DIMMs

of different sizes and speeds.

See Figures 5-5a and 5-5b for installing and removing memory modules.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 109 110

Sin comentarios

SUPER MICRO Computer SUPERSERVER 6012P-6 Manual de usuario Pagina 44