SUPER MICRO Computer Server AS1041M-82 Manual de usuario Pagina 69

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 104
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 68
Chapter 6: Advanced Chassis Setup
6-7
2. Installing/removing hot-swap SATA/SCSI drives
The SATA/SCSI drive carriers are all easily accessible at the front of the chassis.
These hard drives are hot-pluggable, meaning they can be removed and installed
without powering down the system. To remove a carrier, push the release button
located beside the drive LEDs. Then swing the colored handle fully out and use it
to pull the unit straight out (see Figure 6-5).
Note: Your operating system must have RAID support to enable the hot-plug ca-
pability of the SATA/SCSI drives.
Figure 6-5. Removing a SATA/SCSI Drive from the Server
SCSI/SATA Backplane
The SCSI/SATA drives plug into a backplane that provides power, drive ID and bus
termination. A RAID controller can be used with the backplane to provide data
security. The operating system you use must have RAID support to enable the
hot-swap capability of the drives. The backplane is already preconfi gured, so there
are no jumpers or switches present on it.
Vista de pagina 68
1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 103 104

Comentarios a estos manuales

Sin comentarios